Bulk Gravel Delivery to Hyattsville, MD

Maryland Rock Supply handles gravel and aggregate delivery in Hyattsville, MD. Path and paver work here runs spring through late fall, with only short stoppages for frozen ground. Plan your order around that window and you avoid a load sitting on wet clay.

Start with CR-6, the standard Maryland base blend of crushed stone and dust. It compacts hard and locks in place, which is what a path or driveway needs underneath it.

Materials for Hyattsville Projects

In Hyattsville, a pathway holds up because of its fines and what lies beneath them. The top layer is what you walk on, but the bedding and base under it decide whether the surface stays flat. A path built on bare ground will rut and shift within a season.

Stone dust, which yards around here call screenings, is the usual choice for paver and flagstone bedding. It beds evenly and holds a joint. Order Screenings for that layer.

For the base under a path or patio, use CR-6. Tamp it in lifts, wet it, and repeat. It binds to a firm, near-concrete surface. Order CR-6.

Top the path itself with a finer, walkable stone. Walkway Gravel is sized for paths and garden walks, and 3/8" Natural Pea Gravel works where you want a smoother, looser surface.

For drainage beside a path, run #57 Stone in a trench or French drain. It lets water through instead of holding it against the bedding.

Ground and Conditions in Hyattsville

A thin base shows itself fast here. You get ruts at the edges, low spots after rain, and joints that open as the pavers rock. That is the failure mode in this part of Prince George's County.

The ground is unconsolidated sand, silt, clay and gravel, not bedrock. Higher spots drain sandy and firm up well. Low, flat ground holds water and stays soft, especially after summer thunderstorms and nor'easters.

The fix is depth and compaction. Dig out soft material, put down a thicker CR-6 base, and compact it in lifts. Frost depth in Prince George's County is set at 30 inches, so a shallow base over wet clay will heave with repeated freeze-thaw.

Near tidal water, Critical Area rules limit lot coverage, and gravel and stone surfaces count toward it. Keep that in mind if you are adding a path or pad close to the shore.

Delivery to Hyattsville and the Surrounding Area

Order online and choose your quantity. Bulk material is sold by the ton or by the cubic yard, and the two are not interchangeable, so check which one the listing uses before you buy.

To estimate, measure your area and decide on depth. A path with a thin surface layer needs far less than a thick driveway base. Multiply length by width by depth, then convert.

Delivery is bulk, so the truck needs a clear drop spot with room to spread or dump. Maryland Rock Supply covers Hyattsville and nearby parts of Prince George's County, including Bowie, Clinton, College Park, Laurel and Suitland.

Order Your Path Material for Hyattsville

Use the quantity calculator on each product page to turn your measurements into tons or yards before you order. That keeps the load right the first time. Maryland Rock Supply delivers bulk gravel, stone, sand and soil across Hyattsville, so pick your material and place the order.